ADAMS FORGED 1350 Series 1 1/2" x 16 Spline High Angle Slip Yoke.
Why Buy Adams Forged?
Because this is the Strongest Forged 1350 series Slip Yoke on the Market that will fit a CV Driveshaft or Weld Yoke Style Driveshafts with a 1 1/2" 16 spline stub. Adams Custom made this slip yoke with a lot of upgrades in mind. We have inset the grease zerk so it won't break off on Rocks, etc. We had the yoke specially machined to take less balancing weight and a better style dust cap to help keep out the contaminates. It can be used on Front or Rear Driveshafts with a 1 1/2" 16 spline stub.
This Slip Yoke Specs, Advantages, and Measurements are:
- 16 splines and 1.5 inch Spline Diameter.
- 8.44 inches from center of u-joint bearing cap to end of the yoke.
- The yoke is specially machined to take less balancing weight.
- Has a Better style dust cap with a rubber seal to keep out contaminates.
- Gives you a 35 Degree Angle unlike others that give you 20 Degree.
- Longer than most other Slip Yokes by over 1".
- Zerk fitting is recessed so it won't break off on the rocks.
- Lifetime Warranty against breakage.
Made to Fit a 1350 Series U-joint with the measurements of:
. 3-5/8 inches between snap rings
. 1-3/16 diameter bearing caps